Dns Settings; Restrict Access To Switch Management Page - TRENDnet TPE-30102WS User Manual

TRENDnet User's Guide

DNS Settings

System > DNS Settings
This section allows you to connect to a specific DNS server with a specific IP address.
1. Log into your switch management page (see
on page 11).
2. Click on System, and click on DNS Settings.
3. Review the settings.

DNS IPv4 Server – Input the IPv4 IP address where you want the switch to
connect to.

DNS IPv6 Server – Input the IPv6 IP address where you want the switch to
connect to.
Note: You can enter both the IPv4 and IPv6 IP addresses, or you can enter either one.
4. Click Apply.
5. Click Save Settings to Flash (menu).
6. Click Save Settings to Flash (button), then click OK.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

Restrict access to switch management page

System > IP Access List
This section allows you to define or restrict access to the switch management page to a
list of specific IP addresses.
1. Log into your switch management page (see
on page 11).
2. Click on System, and click on IP Access List.
3. Review the settings.
First, enter the IPv4 or IPv6 address to allow access and click Add for each entry.
For each entry, the access list will populate. You can click Delete next to the entry to
delete the entry or Delete All to delete all entries in the table.
When you have completed entering the IPv4 and IPv6 address entries, click the IP
Restriction Status drop-down list at the top and select Enabled, then click Apply.
TPE-30102WS
"Access your switch management page"
19