TRENDnet TPE-30102WS User Manual page 66

TRENDnet User's Guide

Enter a number in the VLAN ID field. A unique number identifying a VLAN
ranging from 1 to 4094.

Enter a number in the 802.1q Priority field. Enter the priority level of the frame
ranging from 0 – 7.

Choose the parameters to add for the policy, and enter data one or more of the
parameters required for your policy. They are listed here:
o
IP Protocol – Select from the drop down menu the type of IP Protocol
(TCP, UDP, ICMP, Other or Any) and fill in the unique number
identifying the range of 1 – 255
o
DSCP: The DSCP (Differentiated Services Code Point) value in the IP
header ranging from 0 - 63
o
IPv4 Source IP Address - Specifies the IPv4 Source IP address.
o
Mask Length – Indicates the length of the Sender IP Address ranging
from 1 – 32
o
IPv4 Destination IP Address - Specifies the IPv4 Destination IP
address.
o
Mask Length – Indicates the length of the Sender IP Address ranging
from 1 – 32
o
ICMP Type – The ICMP (Internet Control Message Protocol) value
ranging from 1 – 255
o
ICMP Code – The ICMP (Internet Control Message Protocol) value
ranging from 1 – 255
o
Source Layer 4 Port – Indicates the source layer 4 port ranging from 1
– 65535
o
Destination Layer 4 Port – Indicates the destination layer 4 port
ranging from 1 – 65535
o
Policy Action: In the Permit/Deny field, use the pull down menu to
select one of the following parameters:

Deny - This selection drops ingress packets that conform to
the specified Replaced-CoS or Replaced-DSCP.

Permit - This selection allows ingress packets that conform to
the specified Replaced-CoS or Replaced-DSCP to be
processed by the switch.
© Copyright 2018 TRENDnet. All Rights Reserved.
o
Policy Action: In the Permit/Deny field, use the pull down menu to
select one of the following parameters:

Deny - This selection drops ingress packets that conform to
the specified Replaced-CoS or Replaced-DSCP.

Permit - This selection allows ingress packets that conform to
the specified Replaced-CoS or Replaced-DSCP to be
processed by the switch.
Note: You must enter a selection for Deny/Permit field even if the
Profile Action ID that you have entered ignores both the Replaced-
DSCP and Replaced-CoS fields.
o
Rate Control Index: The Rate Control Index is a unique number within
the range of 1 - 65535. This field is mandatory and must match a Port
List Index that has been previously entered on the Policy Index.
o
Ingress Port List: Select the interface for which you want to display
data.
Add IPv6
To add an IPv6 policy, use the following procedure:

Click Add IPv6, The Policy Settings page.

Enter a number in the Policy Index field. The Policy Index is a unique number
within the range of 1 – 256 which identifies the policy. This field is mandatory.

Enter a number in the VLAN ID field. A unique number identifying a VLAN
ranging from 1 to 4094.
TPE-30102WS
62