TRENDnet TPE-30102WS User Manual page 67

TRENDnet User's Guide

Enter a number in the 802.1q Priority field. Enter the priority level of the frame
ranging from 0 – 7.

Choose the parameters to add for the policy, and enter data one or more of the
parameters required for your policy. They are listed here:
o
IP Protocol – Select from the drop down menu the type of IP Protocol
(TCP, UDP, ICMP, Other or Any) and fill in the unique number
identifying the range of 1 – 255
o
DSCP: The DSCP (Differentiated Services Code Point) value in the IP
header ranging from 0 – 63
o
IPv6 Source IP Address - Specifies the IPv6 Source IP address
o
Prefix Length - Indicates the length of the Source IP ranging from 1-
32.
o
ICMP Type – The ICMP (Internet Control Message Protocol) value
ranging from 1 – 255
o
ICMP Code – The ICMP (Internet Control Message Protocol) value
ranging from 1 – 255
o
Source Layer 4 Port - Indicates the source layer 4 port ranging from 1 -
65535.
o
Destination Layer 4 Port - Indicates the destination layer 4 port
ranging from 1 - 65535.
o
Policy Action: In the Permit/Deny field, use the pull down menu to
select one of the following parameters:
o
Deny - This selection drops ingress packets that conform to the
specified Replaced-CoS or Replaced-DSCP.
o
Permit - This selection allows ingress packets that conform to the
specified Replaced-CoS or Replaced-DSCP to be processed by the
switch.
Note: You must enter a selection for Deny/Permit field even if the
Profile Action ID that you have entered ignores both the Replaced-
DSCP and Replaced-CoS fields.
o
Replaced-CoS: Enter a number in the Replaced-CoS field ranging from
0 to 7. This field indicates the CoS level of interest. This field is not
mandatory and you may elect to leave it blank
o
Replaced-DSCP: Enter a number in the Replaced-DSCP field within the
range of 0 to 63. This field indicates the DSCP level of interest. This
field is not mandatory and you may elect to leave it blank.
© Copyright 2018 TRENDnet. All Rights Reserved.
o
Rate Control Index: The Rate Control Index is a unique number within
the range of 1 - 65535. This field is mandatory and must match the
Rate Control Settings page.
o
Ingress Port List: Select the interface for which you want to display data.

Click Add to add the policy to the Policy Table.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
4. Click Save Settings to Flash (menu).
TPE-30102WS
63