Configure Poe Budget; Configure Poe Port Settings - TRENDnet TEG-3102WS User Manual

TRENDnet User's Guide

Configure PoE Budget

PoE > Power Budget
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on PoE and click on Power Budget.
3. Enter the max PoE budget of the switch. The total consumed wattage is also shown.
Note: By default, the PoE budget is set to 240W (maximum budget).
4. Click Apply to save your settings to the flash.

Configure PoE Port Settings

PoE > PoE Port Settings
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on PoE and click on PoE Port Settings.
3. Review the settings for each port.
•
State - The PoE port status is given as follows:
o
ON - The port is supplying PoE power.
o
OFF - The port is not supplying PoE power.
•
Priority - Indicates the port priority: Low, High, or Critical.
© Copyright 2022 TRENDnet. All Rights Reserved.
Multi-Gig Web Smart Switch Series
•
Power Limit Type – Indicates the power limit by class or power limit defined by
the user.
•
User Power Limit(W) -
•
Status – Displays the current status
•
TimeRange – Select a defined PoE TimeRange. N/A will be displayed if no time
ranges have been created.
•
Class - The PoE class is indicated the class of the PD. N/A is displayed when the
port is not supplying power
•
Output Voltage(V) - Indicates the Voltage in volts as measured at the port
when the port is supplying power to the PD.
•
Output Current(mA) - Indicates the Current in milliamps that the port is
supplying to the PD.
•
Output Power(mW) - Indicates the Power in milliwatts that the port is
supplying power to the PD.
4. To modify the settings, select the port and click Edit. Review the settings below and
click Apply to save your settings to the flash.
•
State – Select Enabled to enable PoE on this port or Disabled to disable PoE
from the selected port.
•
Priority – Set the priority of this port.
•
Power Limit Type – Select Auto Class for the switch to determine the amount of
power need to power your PD or User defined to manually define the amount of
power your PD device needs.
•
Schedule Name – Select the schedule rule to follow.
Note: In order to set the schedule, the "Time Range" must first be configured.
61