Configure Igmp Snooping Port Settings; Configure Igmp Snooping Table Vlan Parameters - TRENDnet TEG-30102WS User Manual

TRENDnet User's Guide

Configure IGMP Snooping Port Settings

Bridge > IGMP Snooping > Port Settings
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on IGMP Snooping, and click on Port Settings.
3. Review the settings.

Static Router Port – Enable or Disable will allow the switch to connect directly
to the static router IP address.

Fast Leave – This allows the switch to send information to the last member of
the host.
o
Enable: Enable will enable IGMP Snooping Fast Leave
o
Disable: Disable will not have IGMP Snooping Fast Leave

Filter Profile – This allows the switch to filter the types of data that goes
through switch
4. Click Apply.
5. Click Save Settings to Flash (menu).
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
6. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

Configure IGMP Snooping Table VLAN parameters

Bridge > IGMP Snooping > Basic Settings
1. Log into your switch management page (see
on page 11).
2. Click on Bridge and click on IGMP Snooping.
3. Review the settings. Click Apply to save the settings.

Status – Click the drop-down list and select Enabled to enable the IGMP
snooping feature or Disabled to disable the feature.

Querier Election – Click the drop-down list and select Enabled to enable the
Querier Election or Disabled to disable this feature.

Compatibility – Click the drop-down to select Auto (automatically detect which
IGMP version to use) or force the use of a specific IGMP version.

Querier Interval – Enter the amount of time you want your switch to send
IGMP queries.

Max Response Time – Enter the maximum response time in seconds that client
can wait before responding to a query.

Robustness Variable – Enter the robustness value used to determine the
number of times to send a message.
TEG-30102WS
"Access your switch management page"
38