Advertisement
NCA-5530 User Manual
Installing the PHM onto the Motherboard
1. Remove the socket cover from the
socket contacts of the motherboard by
grasping the tabs on either side.
Squeeze inward
Note: Inspect the surface of the socket
under sufficient lighting to ensure there is
no contamination or damage prior to the
PHM installation.
2. Set each anti-tilt wire to inward or
unlocked position on the heatsink.
3. Lift up the PHM. Turn the PHM over to
locate the
PIN1
corner on processor
carrier and processor.
4. Then turn the PHM right side up. Line
up the
PIN1
corner of the PHM to the
bolster plate
PIN1
PHM vertically down over the bolster
plate studs.
corner. Lower the
32
Advertisement
