JLG LiftPod FS60 Operation, Safety, Service And Maintenance Manual page 92

SECTION 7 - TROUBLESHOOTING
TROUBLE
Machine does not wheel properly
Retractable Swivel Castor is not properly
deployed
Castor is damaged
Base will not level (DO NOT ELEVATE UNLESS BASE FIRM AND LEVEL)
Castor deployed
Machine rocks slightly side to side
Support surface is not level
Adjustable feet are not BOTH in contact with
supporting surface
Ropes are worn or a rope is broken or machine is 5 years old or machine has been in service for 5 years since previous service
Damage or wear or machine is 5 years old
1001070465
7-4
PROBABLE CAUSE
With no load in the platform or on the base - lift the castor deploy handle on front of
base, adjacent to platform gate. Castor should deploy and lift front of machine off
adjustable feet to allow machine to roll easily on rear wheels and front castor.
Replace castor.
With no load in platform and people clear of adjustable feet - exert approximately
25kg pressure onto front of base. Castor should retract. Adjustable feet should
then be able to be used to level the machine on slopes less than 2 degrees front to
back. Do not use the machine on any side slope.
Only use the machine on firm and level surfaces.
Adjust the feet so that BOTH feet are in firm contact with supporting surface AND
the machine is level.
Deliver unit to an Authorized JLG Service Center for replacement.
REMEDY
LIFTPOD by JLG