10. Platform Assembly and Gate - Check mounting pins
are not loose; platform railing is undamaged; platform
latch is engaged on carriage (Figure 2-7.); self-closing
entry gates are in proper working order; no cracks or
corrosion visible.
11. Tool Tray - See next page for Tool Tray Pre-Start Inspec-
tion Procedure.
Figure 2-4. Examples of new, acceptable and
unacceptable ropes
LIFTPOD by JLG
SECTION 2 - PREPARATION AND INSPECTION
Mast Cap
Mast
Figure 2-5. Ropes retained in mast cap
Top of
Mast
Figure 2-6. Rope anchor points
Check both ropes
are retained in
groove in cap
The two upper rope tails
should be slack.
Check that each termination is
engaged under its anchor point
by viewing through the cover.
The lower rope loop should
be tight around anchor.
1001070465
2-7