Table of Contents
Advertisement
TROUBLE
Platform will not move when in elevated position - motor starts
Driveshaft interlock is engaged
(If using powerpack) Powerpack shaft not
engaged
Drive shaft malfunction
No load in platform & will not lower
Ropes are loose (ropes must never be loose)
Machine was disassembled without platform
being fully lowered to engage the carriage lock
down latch. Carriage then moved up the mast
loosening the ropes
LIFTPOD by JLG
PROBABLE CAUSE
SECTION 7 - TROUBLESHOOTING
Push cordless drill on driveshaft down firmly to disengage driveshaft safety inter-
lock.
Check powerpack charged and in correctly fitted and is fully down and latched
down.
Lower platform using manual descent procedure (see Section 4.1). Refer to
Authorized JLG Service Center.
If carriage is not within 1m (3 ft) of the base of the mast contact Authorized JLG
Service Center. If carriage is within 1m (3ft) from ground, apply load in platform,
drive up 1", then drive down.
If carriage is not within 1m (3 ft) of the base of the mast contact Authorized JLG
Service Center. Otherwise follow rope re-tensioning procedure detailed in Section
6.7, point 3. Ensure both ropes are tight and remain so at all times.
REMEDY
1001070465
7-3
Advertisement
Table of Contents
