Prerequisites; System Overview - Xilinx MicroBlaze ML605 Hardware Tutorial

Prerequisites

Prerequisites
Prerequisites required to run the basic tutorial are:
•
•
•
•
•
•

System Overview

This tutorial is based on the ML605/SP605 Embedded Kit MicroBlaze Processor
Subsystem. Readers are encouraged to refer to DS668, AXI Interface Based ML605 Embedded
Kit MicroBlaze Processor Subsystem Data Sheet
Embedded Kit MicroBlaze Processor Subsystem Data Sheet
tutorial.
6
ML605 MicroBlaze Processor Subsystem:
• Proper hardware setup and software installation, as described in UG668, Getting
Started with the Virtex-6 FPGA ML605 Embedded Kit
• Familiarity with the ML605 MicroBlaze Processor Subsystem, documented in
DS668, AXI Interface Based ML605 Embedded Kit MicroBlaze Processor Subsystem
Data Sheet [Ref 3]
SP605 MicroBlaze Processor Subsystem:
• Proper hardware setup and software installation, as described in UG667, Getting
Started with the Spartan-6 FPGA SP605 Embedded Kit
• Familiarity with the SP605 MicroBlaze Processor Subsystem, documented in
DS667, AXI Interface Based SP605 Embedded Kit MicroBlaze Processor Subsystem Data
Sheet [Ref 5]
Familiarity with UG683, EDK Concepts, Tools, and Techniques, Chapter 1 (Introduction),
Chapter 3 (Using Xilinx Platform Studio), and Chapter 4 (Working with the Embedded
Platform) [Ref 1]
General knowledge of FPGAs, digital design concepts, and microprocessors
Basic familiarity with the ISE Design Suite
Basic VHDL/Verilog knowledge
www.xilinx.com
[Ref 2]
[Ref 4]
[Ref 3] or DS667, AXI Interface Based SP605
[Ref 5] during the execution of this
ML605/SP605 Hardware Tutorial
UG669 (v3.0) March 15, 2011