Advertisement
Deactivating the alarm system (without alarm memory)
Pressing the (dotted) button #1 on the remote control or inserting the electronic
key in the receptacle will deactivate the alarm.
The alarm system will signal this change of status with the led switched off,
three beeps and three flashes of the direction indicators at the same time.
Eactivating the alarm system (with alarm memory)
If during the armed period attempts have been made to force the vehicle,
during the deactivation stage the alarm will signal the event with two flashes of
the direction indicators and, simultaneously, with two low-tone beeps.
The last cause of alarm will be signalled with one or more flashes of the turn
signals and a corresponding number of beeps, according to the type of event.
!
Starting attempt alarm
: two flashes of the turn signals, two flashes of the
led and two low-tone signals
.
!
Trunk open/lift-up seat alarm
: three flashes of the turn signals, three
flashes of the led and three low-tone signals
!
Cables cut alarm
: four flashes of the turn signals, four flashes of the led
and four low-tone signals
.
!
Shifting/hitting alarm
:
five flashes of the turn signals, five flashes of the
led and five low-tone signals
.
Hazard signalling
The hazard signalling is useful when you want to park the vehicle, being the
engine off and the turn signals on.
To activate/deactivate this function, proceed as follows:
!
Switch off the engine, by turning the ignition key to "OFF".
!
Turn the ignition key to "ON"; the LED will be illuminated for about 1".
!
During this period, push the button nr 2 of the radio control.
!
Turn the ignition key to "OFF"; the turn signals will start flashing.
!
To deactivate the function, you must just turn again the ignition key to "ON"
(and eventually to "OFF"), or arm and disarm the system by a remote (or
electronic key).
PAG.8
.
DESCRIPTION OF THE EXTRA FUNCTIONS
The table below shows the programmable functions.
The manufacturer supplies the alarm with some of these functions disabled in
order to achieve a good trade-off between ease and completeness of use)
being the shock sensor regulated at a standard sensibility.
Factory settings
Function
Acoustic signals
Panic alarm
!
Acoustic and optical signalling:
alarm signals the current operation or the alarm memory.
This is done using the direction indicators for the optical signals and using
the siren for the acoustic signals, which can be disabled.
!
Operation
:
during the stages of activation, deactivation, alarm memory,
function programming, and recognition of new remote controls, the alarm
will produce specific acoustic signals in order to show which function is
being run.
The acoustic signals can be high-tone or low-tone.
!
Remote controlled panic alarm:
It allows to generate an alarm condition
by pressing button #2 on the remote control.
The panic signals can be as many as desired, but a minimum 5-second
interval must occur between two consecutive signals.
!
Operation:
Pressing button #2 on the remote control will activate the loud-
sound siren and the direction indicators for about 30 seconds.
To deactivate the panic alarm, just press again button #2 on the remote
control.
This alarm signalling can be activated indifferently of the status of the alarm
(activated/deactivated).
SLEEP MODE ACTIVATION/DEACTIVATION
When the vehicle is not used, it is possible to switch completely off the alarm
(sleep mode) in order to reduce the battery charge consumption.
To activate this function, proceed as follows:
!
Turn the ignition key to "ON" position; the led will light for about one
second.
!
Put the electronic key into the receptable, within 4 seconds.
!
An acoustic signal will indicate that the alarm is turned off.
!
Turn the ignition key to "OFF" position.
!
To re-activate the alarm, turn the ignition key to "ON" and "OFF".
,
State
Enabled
Enabled
In the different usage conditions, the
PAG.9
Advertisement
