Download Print this page

Advertisement

Quick Links

Advertisement

loading
Need help?

Need help?

Do you have a question about the RTA-B002 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Techni Mobili RTA-B002

  • Page 3: Main Parts List

    MAIN PARTS LIST Left panel Right panel panel panel panel panel SCREWS LIST:...
  • Page 4 MAIN PARTS LAYOUT ( FOR REFERENCE ): This unit uses cam bolts and locks. The following explains how to use them. This is not an assembly step; it is a guide for when you are actually doing the assembly using this kind of hardware.
  • Page 5 BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS. ❼ ❶ To avoid misalignments, Do a quick inventory to always leave the screws loose make sure the package contains and tighten them until all all the parts and hardware listed pieces are positioned correctly.
  • Page 6: Assembly Steps

    ASSEMBLY STEPS First screw bolts ( into panel ( 1 ), then place down the Back panel ( 4 ), the Front STEP 1 panel ( 5 ) and the and assemble them by turning the cam locks on Item: those panels as shown and as explained in page 3.
  • Page 7 STEP ottom surface of the bottom panel ( 7 ). Item: Please note that the LOCKING casters go at the FRONT. x mm NON-LOCKING go at the back LOCKING go at the front (Front) First screw the top surface of the ), then place down and STEP assemble...
  • Page 8 First screw the ), then place it down and assemble it STEP to the structure by turning the cam locks on panel ( 1 ), ( 2 ) and ( 4) as shown and Item: as explained in page 3. 6x mm STEP Item:...
  • Page 9 over the with their STEP 7 holes facing towards the outside Hole facing to the outside through screw in the STEP . Make sure to raise and set the tubes a little bit higher and at the same level for easy accessibility during the next step. Longer end on the tubes face towards the front.
  • Page 10 STEP from underneath. Item: 6x 5mm STEP STEP 1 Screws: from underneath. x mm...
  • Page 11 FINAL...
  • Page 12 AFTER THE ASSEMBLY IS DONE, PLEASE READ CAREFULLY THE FOLLOWING WARNINGS FOR CARE AND MAINTENANCE: Do not exceed the indicated weight limits. Do not expose the surfaces to direct sunlight or to extreme environmental conditions. Clean the surfaces preferable with a clean cloth damped in a solution of mild soap and water, then dry with a clean towel.

This manual is also suitable for:

Rta-b002-gph06Rta-b002-wg01