Table of Contents
Advertisement
5 INSTRUCTIONS FOR USE
5.1
Introduction
The power supply voltage must
never be less than 205V AC, with a stable
frequency of 50Hz.
Outside the specified operating
temperature range, the efficiency of the air
conditioner is reduced considerably.
The ICE S 2800 air conditioner consists of
nine main parts:
•
compressor, which circulates the coolant
gas through the system.
•
condenser, which cools the coolant by
changing it from a gaseous to a liquid
state.
•
evaporator, which, cooled by the change
of state of the coolant, cools the air
passing through it.
•
two fans, which move the air so that it
passes
through
evaporator
•
solenoid valve, which switches gas
circulation and so provides a cooling or
heating function
•
remote control to program the desired
function
•
receiver, situated in the diffuser, which
receives the remote control signals
•
electronic board, which receives the
signals from the receiver and transforms
them into commands for the various
electrical
components
conditioner.
The ICE S 2800 provides cold air during the
summer months and hot air in winter.
If the vehicle has been left in the sun for
some time it is good practice to open
windows and doors before starting the
conditioner so as to release the build up of
heat in the interior; once indoor temperature
matches outdoor temperature close the
windows and doors and start the air
conditioner. Subsequently, only open doors
and windows when necessary.
ICE S 2800
the
condenser
and
of
the
air
5.2
Preliminary checks
Before switching on the air conditioner for the
very first time:
•
Check that condensate drainage holes
are unobstructed.
•
Check that the power supply voltage and
frequency
specifications.
•
Check that air flow through relative ducts
and vents is unobstructed. To ensure
maximum efficiency always keep external
ventilation grilles clear.
When the equipment is started for
the first time with the remote control, the
fan and compressor will also start within a
few seconds. After a power-off, upon the
next power-on the compressor will only
start after at least 3 minutes from the
power-off.
5.3
Useful tips
•
Enhance the thermal insulation of the
camper by eliminating any fissures and
covering
glass
reflecting curtains.
•
Avoid
frequent
windows unless necessary.
•
Select a suitable temperature and airflow
rate.
•
Adjust the outflow vents to maximise
comfort.
•
Never close both adjustable vents when
the conditioner is running.
•
Clean the diffuser filters periodically.
•
Do not obstruct airflow inlets/outlets with
fabric, paper or anything else.
•
Do not spray water inside the air
conditioner.
•
Remove the remote control battery if you
do not intend to use the conditioner for a
long period.
•
Periodically check that the condensate
drain holes are not obstructed.
•
Periodically check that external intakes
grilles are clean so as to maintain
maximum air conditioner efficiency.
•
Clean the air conditioner with detergent
solutions only; never use petrol or
solvents.
12
match
the
required
surfaces
with
opening/closing
Rev.001
heat-
of
Hide quick links:
Advertisement
Table of Contents
