Setting System Time On Remote Control; Automatic Operation Mode; Cold Operation Mode; Heating Operation Mode - Telair ice S2800 Manual For Installation And User Manual

- Fan = ventilation only mode
The third field (Fig. 20 ref. 3) shows fan
mode.
The two figures in the first field (Fig. 20 ref. 1)
normally indicate the ambient temperature
detected by the air conditioner inside the
camper.
When setting the desired temperature with
the remote control, the two digits show the
set temperature for about 15 seconds; they
then show the temperature in the camper
interior again.
5.9 Setting system
control
After inserting the batteries, set the system
time on your remote control:
1) Press and hold down the SET key on
your remote control until the system time
digits start flashing
2) By using the +HOUR and –HOUR keys,
set your system time
3) Press the SET key once again

5.10 Automatic operation mode

1) Press the On/Off key
2) Press the MODE key repeatedly until the
display shows the Automatic mode
symbol
3) Set your required temperature with the
keys +TEMP and –TEMP
4) Press the FAN key several times until you
reach your required ventilation setting.

5.11 Cold operation mode

1) Press the On/Off key
2) Press the MODE key repeatedly until the
display shows the COLD mode symbol.
3) Set your required temperature with the
keys +TEMP and -TEMP.
4) Press the FAN key several times until you
reach your required ventilation setting.
Rev.001
time on remote

5.12 Heating operation mode

1) Press the On/Off key
2) Press the MODE key several times until
the display shows the HOT mode symbol.
3) Set your required temperature with the
keys +TEMP and -TEMP.
4) Press the FAN key several times until you
reach your required ventilation setting.

5.13 Ventilation operation mode

1) Press the On/Off key
2) Press the MODE key several times until
the display shows the VENTILATION
mode symbol.
3) Press the FAN key several times until you
reach your required ventilation setting.
If the air conditioner is switched off
and immediately
operating mode is changed, a three-
minute interval will elapse before the
compressor resumes operating.
If the air conditioner is turned off
during the heating mode, the fan will
remain in operation for a few minutes in
order to dissipate the heat accumulated
inside the air conditioner, before stopping
automatically.
In cooling mode, the external
condensing
automatically depending on the required
performance and
temperature.

5.14 Timer setting

1) Press the TIMER key on the remote
control: the start time ON indicator is
activated
2) By using the +HOUR and –HOUR keys,
set the start time
3) Press the TIMER key once again: the
stop time OFF indicator is activated
15
re-started or
fan speed changes
the environmental
ICE S 2800
the