Table of Contents
Advertisement
Forklift Installation
CAUTION!
!
T
PCS100,
O MOVE THE
915
(36-
CM
INCH
CAUTION!
!
T
HE ENCLOSURE MUST BE LIFTED FROM THE BOTTOM
ALL FOUR SIDES WHEN LIFTING
ENCLOSURE FRONT TO BACK AND SIDE TO SIDE DURING LIFTING BECAUSE THE CENTER OF GRAVITY
OF THE ENCLOSURE IS NOT THE CENTER OF THE ENCLOSURE
1. Unpack the PCS100, see "Unpacking the Unit" on page 12.
2. Using the forklift to move the PCS100.
Removing the PCS100 from left/right side:
a. Remove the hexagonal nuts and washers securing cabinet to the pallet.
b. Remove the screws securing the side base covers.
c. Remove the base covers. Place them in a clean work surface for later use. The covers must
be replaced after cabinet installation and cable routing is completed.
Installation Manual
USE A FORKLIFT THAT HAS AN APPROPRIATELY RATED LIFT CAPACITY AND A
)
.
FORK SPAN
. P
RECAUTIONS MUST BE TAKEN TO AVOID TIPPING OF THE
Figure 24.
Releasing a PCS from a Pallet
. T
HE ENCLOSURE MUST BE SUPPORTED ON
.
24
Installation
Hide quick links:
Advertisement
Table of Contents
