Foundation - Delta PCS100 Installation Manual

Foundation

The PCS cabinet is recommended to be mounted on concrete floor. Follow the illustration below to
prepare the groundwork.
Before installing a PCS cabinet, it is recommended to have a solid foundation established. The
following information is provided to serve as a guide for the setup of a recommended foundation.
The footprint boundary area of the PCS is 600 x 800 mm (23.62 x 31.49 in.), and there are two ways for
mounting:
1. Mounting by the left and right sides of the unit base: Drill four holes for M16 expansion bolts at
the 4 corners of an area of 560 x 460 mm (22.05 x 18.11 in.) as marked in number 1.
2. Mounting by the front and rear sides of the unit base: Drill four holes for M16 expansion bolts at
the 4 corners of an area of 300 x 746 mm (11.81 x 29.37 in.) as marked in number 2.
Figure 4. Mounting Layout and Anchoring Holes Placement Variations (Top View)
Once the anchoring holes are completed, insert the expansion sleeves into the anchoring holes:
 Remove four M16 expansion bolts from the accessory kit.
 Separate the nuts and washers from the bolts.
 Once the expansion sleeves are individually separated, insert each one into the anchoring
holes.
Installation Manual
600 mm (23.6 in)
Cabinet outline dimension
560 mm (22.04 in)
Expansion bolt
300 + - 5 mm (11.8 in)
Expansion bolt
2 2
1
1
2 2
8
1
1
Installation