Product Features - Ikegami HLE-1853G Operation Manual

Product Features

■
Integrated Converter
Multi-Format Signal
3G-SDI: 3Gb/sec 4:4:4 HD
SDI-HDMI Loop Through
12Bit Internal Processing
2K Input Capability
Under Monitor Display
Menu Jog Control
Waveform Monitor
Vector Scope Monitor
Pixel to Pixel Mapping
De-Embedded Audio Level Meter
Aspect Format Markers
Gamma Encoding Select
Time Code
Time code reader displays embedded LTC or VITC formats
H/V Delay
View the blanking area and synchronize signals by displaying the horizontal and vertical intervals in the center
of the screen
RJ-45 Remote Control
Product Features
Integrated active SDI-HDMI and HDMI-SDI converter allows the transparent conversion of HD to
HDMI signal or conversion of HDMI back to HD format
ViewZ monitors are compatible with various sources including
- HDMI (compatible with DVI)
- SDI signals: 3G(425A/B), HD, SD
- CVBS(composite) and YPbPr(component)
SMPTE 425 compliant HD display that supports frame rates of 50.60 in 1080p, 1080i, and
720p
Supports full SMPTE 425 signal conversion transparency from SDI to HDMI with test and
measurement overlays
Allows for color temperature and gamma encoding changes to be implemented quickly. Active
Video Looping supports full 1080p/60 frames on the HDMI output
2k content can be displayed on ViewZ monitors without the loss of HD signal by converting and
downscaling the content
UMD function displays ancillary data at the bottom of the screen
Jog dial on the front of the monitor enables users to control all features
Onscreen display of video levels with respect to time, used to calibrate multiple camera setups and
vertical blanking level and color burst
On-screen display of chrominance information in Cb and Cr channels. Display can be opaque or
solid against the visual display
1:1 pixel mode displays the original image resolution without scaling to match a certain resolution
or an aspect ratio
De-embedded audio selected out. Auto sensing to display three range meter of
up to 16 ch
4:3, 14:9, 15:9, 16:9 etc. area, line, safety, center markers display
Range from 1.0 to 3.0 users selectable. Factory default setting is 2.8
Plug in your RJ-45 connector to the back of the monitor and communicate with other ViewZ
monitors (RS-485 control / Tally Light Control)
5