Configure Static Wep Security With Microsoft Security; Use Open (No Security) Associations With Microsoft Security - Intermec CK3X User Manual

CK3R and CK3X Mobile Computer User Manual
11 If you selected TLS, enter a User Name and Domain.
12 Tap OK.

Configure Static WEP Security with Microsoft Security

Before you set static WEP security with Microsoft security, you need to
enable the radio on your computer and set the date. Intermec
recommends that you use WPA2-PSK instead of WEP if possible.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Microsoft Security.
3 Enter the Network name (SSID).
4 For Network Authentication, select Open.
5 For Data Encryption, select WEP.
6 For 802.1X Authentication, select Disabled.
7 For Network Key Value, enter an ASCII key or hex key:
• For 64-bit WEP, enter a 5-byte value: 5 ASCII characters or 0x
followed by 5 hexadecimal pairs.
• For 128-bit WEP, enter a 13-byte value: 13 ASCII characters or
0x followed by 13 hexadecimal pairs.
8 For Network Key Index, select the key you want to use to transmit
data.
9 Tap OK.
Use Open (No Security) Associations with Microsoft
Security
To create an open network, you can set no security with Microsoft
security.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Microsoft Security.
3 Enter the Network name (SSID).
4 For Network Authentication, select Open.
Chapter 3 — Configure the Computer
67