Operator Login/Logout - Hyundai HPC-250HT User Manual

USER MANUAL of HPC-250HT

4.3 Operator Login/Logout

The Operator window is an aid to access system components of HPC-250HT which are
restricted in normal operation.
Following actions are restricted until log-in as Operator
- Start MPP Scan cycle
- Change MPP Scan Delay
- Change MPP Mode
- Enable/Disable Fault and Start/Stop Email Sending
- Change System Time and Date
- Change Start and Stop Conditions
- Change Email Settings
- Send Test Email
- Change Utility Network Nominal Voltage and Frequency
- Change Utility Network Voltage and Frequency Tolerances
- Perform Device Test Actions
Log in can be performed by means of an Operator Password. To assign new operator
password to operating personal is only possible in Operator Logged On state.
Note, that improperly modified parameters can partly or completely impair the functionality of
the HPC-250HT.
According to the logged on status of the operator the Status bar available on five of the
eleven user interface pages changes. The logged on status is marked with a red "Logged
ON" label, as displayed in the picture below, whereas the logged off status is indicated by a
"Logged OFF" label as displayed on the picture above.
PE07019-022-B Page 47 of 69