Table of Contents
Advertisement
www.ti.com
6
PDK Kit Setup
NOTE: Do not connect the ADS8339EVM-PDK to a PC before completing
observe this caution may cause Microsoft Windows to disregard the ADS8339EVM-PDK as a
connected device.
This section presents the steps required to setup the ADS8339EVM-PDK kit before operation.
explains how to operate the kit to acquire and analyze data.
The steps to setup the kit are as follows and must be completed before attempting to capture data:
Step 1. Download and install the ADCPro software (if not already installed) on a PC.
Step 2. Download and install MMB0 motherboard drivers.
Step 3. Download and install the ADS8339EVM-PDK EVM plug-in software.
Step 4. Configure the ADS8339EVM-PDK hardware.
Step 5. Power up the ADS8339EVM-PDK.
Each task is described in the subsequent sections of this document.
6.1
Install ADCPro Software
ADCPro is the primary program used to evaluate the ADS8339. ADCPro is available at
www.ti.com/tool/adcpro. Refer to SBAU128, ADCPro User's Guide , for detailed installation instructions.
6.2
Install MMB0 Motherboard Drivers
NOTE: The user must have administrator privileges before attempting to install the MMB0
motherboard drivers.
The driver installer is located at TI's FTP site:
ftp://ftp.ti.com/pub/data_acquisition/ADCPro2/misc/drivers/64bit/mmb0_driver_install_x64-v1.0.0.0.msi.
Download and double-click the file, and then follow the instructions.
Figure 6
shows the initial and completed installer screen shots.
SBAU233A – October 2014 – Revised November 2015
Submit Documentation Feedback
Figure 6. MMB0 Driver Installer
Copyright © 2014–2015, Texas Instruments Incorporated
PDK Kit Setup
Section
6. Failure to
Section 7
ADS8339EVM-PDK
9
Advertisement
Table of Contents
