Secure The Rail Assemblies To The Cabinet; Installing The Front End Of The Rail - Dell EMC ScaleIO Ready Node 14G Hardware Installation Manual

1U1N Configuration Equipment Installation

Secure the rail assemblies to the cabinet

Hardware Installation Guide
34
Figure 10 Installing the front end of the rail
6. Repeat the preceding steps to install the right rail assembly.
The supplied screws and washers are used to secure the rail assemblies to the front
and rear of the cabinet.
Note
For square hole cabinets, install the supplied conical washer to the screw before
installing the screw.
Note
For unthreaded round hole cabinets, install only the screw without the conical washer.
Procedure
1. Align the screws with the designated U spaces on the front and rear rack
flanges.
Note
Ensure that the screw holes on the tab of the system retention bracket are
seated on the designated U spaces.
2. Insert and tighten the two screws using the Phillips #2 screwdriver to secure
the rails to the cabinet.