Install The System In The Cabinet; Installing Screws; Pull The Inner Rails Out Of The Cabinet - Dell EMC ScaleIO Ready Node 14G Hardware Installation Manual

Install the system in the cabinet

Figure 28 Installing screws
This procedure is used to install the system in the cabinet.
WARNING
The system is heavy and should be installed in a cabinet by two people. To avoid
personal injury and/or damage to the equipment, do not attempt to install the
system in a cabinet without a mechanical lift and/or help from another person.
Procedure
1. At front of the cabinet, pull the inner slide rails out of the cabinet until they lock
into place.
Figure 29 Pull the inner rails out of the cabinet
2. Locate the rear rail standoff on each side of the system. Position the system
above the rails and lower the rear rail standoffs into the rear J-slots on the slide
assemblies.
2U1N Configuration Equipment Installation
Install the system in the cabinet
69