Resetting And Restarting The Switch - Lenovo SI4091 Installation Manual

Resetting and Restarting the Switch

1. Log on to the CMM CLI as described in the CMM documentation. If necessary,
2. Set the environment to the bay where you installed the switch. For example:
3. Execute the reset command to restart the switch:
4. Wait for the POST to complete. This may take up to 2 minutes.
5. Execute the info command for the switch that was just restarted and note the
44
SI4091 10Gb System Interconnect Module Installation Guide
To activate the new image or images, you must reset the switch. To reset the switch,
complete the following steps:
obtain the IP address of the CMM from your system administrator.
system> env -T system:switch[1]
system:switch[1]> reset
corresponding level of the firmware for the switch. Confirm that the firmware
build number reflects the correct firmware release. For example:
system:switch[1]> info
...
Boot ROM
Rel date: 01/18/2015
Version: 7.11.0.0
Status: Active
Main application
Rel date: 01/18/2015
Version: 7.11.0.0
Status: Active
Main application
Rel date: 01/18/2015
Version: 7.11.0.0
Status: Inactive