Resetting And Restarting The Switch - Lenovo Flex System Fabric EN4093R User Manual

Resetting and Restarting the Switch

44
EN4093R 10 Gb Scalable Switch User's Guide
To activate the new image or images, you must reset the switch. To reset the switch,
complete the following steps:
1. Log on to the CMM CLI as described in the CMM documentation. If necessary,
obtain the IP address of the CMM from your system administrator.
2. Set the environment to the bay where you installed the switch. For example:
system> env -T system:switch[1]
3. Execute the reset command to restart the switch:
system:switch[1]> reset
4. Wait for the POST to complete. This may take up to 2 minutes.
5. Execute the info command for the switch that was just restarted and note the
corresponding level of the firmware for the switch. Confirm that the firmware
build number reflects the correct firmware release. For example:
system:switch[1]> info
...
Boot ROM
Rel date: 01/18/2015
Version: 7.11.0.0
Status: Active
Main application
Rel date: 01/18/2015
Version: 7.11.0.0
Status: Active
Main application
Rel date: 01/18/2015
Version: 7.11.0.0
Status: Inactive