Advertisement
TROUBLESHOOTING
Error Code Chart
LED Reading
Signal wire is loose
---
Communication failed
Water temperature is
below 0°C or above 50°C
F0
Temperature sensor failure
LED display shows F1
immediately after pressing
FILTER or HEATING
F1
LED display shows F1 15
seconds after pressing
FILTER or HEATING
Problem
Power socket failure
PRCD is off
Display is
blank on the
Pressed the RESET button
controller
and the controller turned
blank.
PRCD is broken.
Cause
•
•
•
Cause
Solution
Contact help.Kogan.com for assistance.
Contact help.Kogan.com for assistance.
Change the water.
Contact help.Kogan.com for assistance.
Clean parts and tubes that the water
goes through.
Add water until the water level reaches
at least the MIN water line.
Clean parts and tubes that water goes
through.
Contact help.Kogan.com for
assistance.
Solution
Use a different socket or repair the
socket before use.
Reset the PRCD by following the PRCD
Testing section of this user guide.
Contact help.Kogan.com for assistance.
Contact help.Kogan.com for assistance.
25
Advertisement
