Advertisement
Spa leaking
Spa is not
heating
properly
Spa loses air
26
Spa inlet and outlet are not
securely tightened
Drainage valve is not closed
completely
Water leaking from the spa
pool body
Temperature set too low
Dirty filter cartridge
Water level is not at the
minimum water line
Heater failure
Filter pump does not work
Temperature protection
switch was set off
Air valve is loose
Hole or split on the spa tub
Tighten the inlet and outlet.
Close the drainage valve.
Contact help.Kogan.com if leaking
persists.
Repair the leaking hole/split with the
included repair kit. Refer to the Spa Tub
and Air Bladder Repair section on page
22 for instructions.
Set to a higher temperature.
Clean or replace the filter cartridge.
Add more water until the water level
reaches the MIN water line marking.
Contact help.Kogan.com for assistance.
Refer to the "Filter pump does not work"
section of Troubleshooting on page 27.
Reset the heater.
Inflate the spa until the Yellow section
of the manometer is pushed out.
Ensure the valve is screwed tightly.
Replace the valve if necessary.
Fill a squirt bottle with soapy water and
spray on the seams. If there is a leak,
small bubbles will come out from the
source.
When you have located the leak, clean
and dry the leaking area, then use the
repair patch supplied with your spa.
Read the Spa Tub and Air Bladder
Repair section on page 22 in this user
guide.
Advertisement
