Advertisement
Filtration
•
Press the FILTER button to turn the function on/off. The light on
the button will turn green when the function is activated.
•
The filtration system will automatically start when the heating is
activated.
•
After turning off the heating system, the filtration system will
automatically stop in 30 seconds.
Note:
When the light on the FILTER button is flashing or displays red, the
filter cartridge must be cleaned or replaced. Once this has been
done, press and hold the FILTER button for 3 seconds to reset.
Bubble Massage
•
Press the BUBBLE button to turn the massage system on/off. The
light on the button will turn green when activated.
IMPORTANT: Do not turn on the massage system when the cover
•
is attached. Air can accumulate inside the spa and cause
irreparable damage and bodily harm.
Note:
The bubbling massage function will shut down automatically after
every 20 minutes of operation as a safety precaution. This can be
reactivated after 10 minutes by pressing the BUBBLE button again.
Heating Timer
•
Press the TIMER button to enter pre-setting mode. The button will
turn green.
•
By pressing the UP or DOWN button, you can set and start heating
automatically in up to 99 hours. This will cause the LED to flash.
While it is flashing, you can adjust the number of hours before
heater activation. The desired timer setting will remain on the LED
display for 3 seconds to confirm the value.
•
To modify the timer setting, press the TIMER button again and use
the UP or the DOWN button to adjust.
•
To cancel the setting, press and hold the TIMER button for 3
seconds.
•
Activating the heating system or rebooting the spa will cancel the
timer setting.
17
Advertisement
