Advertisement
IMPORTANT: The following conditions will lead to slower heating:
16
•
An ambient temperature lower than 10°C.
•
An outdoor wind speed above 3.5-5.4m/s (8-12mph).
•
If the air bubble function is activated when the heater is on.
•
Open the spa top lid when the Bubble function is on.
•
If the spa cover is not properly in place when the heater is on.
Notes:
• If the heating system is turned on, the filtration system will
automatically start.
• When the water temperature is below 1 °C, the anti-icing system
will be activated automatically to heat the water to 3°C.
Adjustment Buttons
•
Pressing the UP or DOWN buttons will cause the LED to flash.
When it is flashing you can adjust the water to the desired
temperature setting (from 20°C to 38°C). The new and desired
temperature setting will remain on the LED display for 3 seconds to
confirm the new value.
•
Press the UP and DOWN buttons at the same time for 3 seconds to
lock/unlock the controller. In the locked mode, all current settings
of the spa are kept. Pressing any buttons in this mode will not
change the settings.
•
To unlock, press the UP and DOWN buttons at the same time for 3
seconds again.
Note:
The default setting temperature is 38°C.
Advertisement
