Advertisement
WARNING: The suction fittings in this spa are sized to match the specific water flow
•
created by the pump. Never operate the spa if the suction fittings are broken or
missing. Never replace a suction fitting with an incompatible one.
Caution: Read the instructions before using, installing and assembling the spa and
•
every time.
Caution: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,
•
this spa must not be supplied through an external switching device, such as a timer or
connected to a circuit that is regularly switched on and off.
•
This spa with its incorporated heating elements must be connected to a grounded
mains supply socket with a supply cord fitted with a plug and a portable residual
current device (PRCD) with a tripping current of 10mA.
•
The pump must be tested before each use. Refer to the PRCD page of the Installation
section for instructions.
•
Contact help.kogan.com for assistance if any parts are damaged or missing upon
arrival.
•
If the supplied power cord is damaged, stop use immediately and contact
help.Kogan.com for assistance.
•
If the spa is damaged, stop use immediately and contact help.Kogan.com for
assistance.
•
No components should be located above the spa during use.
•
Components containing live parts (except parts supplied with safety extra-low voltage
not exceeding 12V) must be out of reach and inaccessible to a person in the spa.
•
It is necessary to have the plug accessible after installation of the spa.
•
The plug of the pump shall be more than 3.5 metres away from the spa at all times.
•
The power source on the wall of a building should keep more than 4 metres away from
spa and at a height of at least 1.2 metres.
•
Do not use extension cords, timers, plug adaptors or converter plugs to connect the
unit to the electrical supply.
•
Parts incorporating electrical components (except remote control devices) must be
located or fixed so that they cannot fall into the spa pool.
•
The wired controller must be properly stored in the side pocket when not in use to
protect it from falling or other hazards.
•
Always unplug the spa:
o
on rainy days
o
before cleaning or other maintenance
o
if leaving unattended for a long period (holidays, etc)
•
The plug shall be directly connected only to a socket-outlet of the fixed electrical
installation.
•
Do not leave the spa filled with water and unattended for long periods. Drain the spa
completely if it will not be used for an extended period. Disassemble and store indoors.
•
Never wear contact lenses when in the spa.
•
Do not use the spa during chemical maintenance.
4
Advertisement
