Table of Contents
Advertisement
A+ SERVER 2122TG-H6IBQRF/H6RF USER'S MANUAL
Checking the Components and Setup
•
You may have one or two processors already installed into the serverboard. Each
processor needs its own heat sink. See Chapter 5 for instructions on processor
and heat sink installation.
•
Your A+ Server 2122TG-H6IBQRF/H6RF server system may have come with
system memory already installed. Make sure all DIMMs are fully seated in their
slots. For details on adding system memory, refer to Chapter 5.
•
If desired, you can install add-on cards to the system. See Chapter 5 for details
on installing PCI add-on cards.
•
Make sure all power and data cables are properly connected and not blocking
the chassis airflow. Also make sure that no cables are positioned in front of the
fans. See Chapter 5 for details on cable connections.
2-7
Checking the Drive Bay Setup
Checking the Drives
Next, you should check to make sure the peripheral drives and the SATA drives
have been properly installed and all connections have been made.
•
All drives are accessable from the front of the server. A hard drive can be
installed and removed from the front of the chassis without removing the top
chassis cover.
•
Depending upon your system's configuration, your system may have one or
more drives already installed. If you need to install hard drives, please refer
to Chapter 6.
Checking the Airflow
•
Airflow is provided by four hot-swappable 8-cm cooling fans. The layout was
carefully designed to direct sufficient cooling airflow to the components that
generate the most heat.
•
Note that all power and data cables have been routed in such a way that they
do not block the airflow generated by the fans.
2-8
Providing Power
1. Plug the power cords from the power supply units into a high-quality power
strip that offers protection from electrical noise and power surges. It is
recommended that you use an uninterruptible power supply (UPS).
2. Depress the power on buttons on the front of the chassis.
2-10
Advertisement
Table of Contents
