Supero A+ 122TG-H6IBQRF User Manual page 103

DRAM ECC Enable
This setting allows hardware to report and correct memory errors
automatically, maintaining system integrity. Options are Enabled or
Disabled.
 DRAM Timing Configuration
DRAM Timing Config
This setting specifies the DRAM timing configuration. Options are Auto and
Manual.
Memory Timing Parameters
This selects the which node's timing parameters to display. Options include CPU
Node 0, CPU Node 1, CPU Node 2 or CPU Node 3.
IOMMU
This setting is used to enable or disable or set the GART size in systems without
AGP. Options include Enabled and Disabled.
OHCI/EHCI HC Device Functions
These settings allow you to either Enable or Disable functions for OHCI or EHCI
bus devices.
USB 2.0 Controller Mode
Use this setting to configure the USB 2.0 Controller in either Hi-Speed (480
Mps) or Full Speed (12 Mps) mode. Options include Enabled (Hi-Speed Mode)
or Disabled (Full Speed Mode).
Legacy USB Support
Select "Enabled" to enable the support for USB Legacy. Disable Legacy support if
there are no USB devices installed in the system. "Auto" disabled Legacy support
if no USB devices are connected. The options are Disabled, Enabled and Auto.
 IDE Configuration
OnChip SATA Channel
This setting allows you to Enable or Disable the OnChip SATA channel.
7-7
Chapter 7: BIOS