Raven CR7 Calibration Manual page 13

CALIBRATE ISO RAVEN STEERING CONTROLLER | CR7 AUTOSTEERING | RAVEN EUROPE GENERIC
Now drive to a flat surface, mark the place of
the rear axle and make sure the whole
machine (including the cab) is completely
29
not moving, shaking or so.
When the place of the rear axle is marked,
press Calibrate.
The system is calibrating the Gyro.
30
Make sure the machine and the cabine is
standing still when calibrating is in progress!
The system shows where the first step of the
calibration is performed. Before the next step
of the calibration can be performed, the
31 machine needs to be turned 180 degrees
(same place, only other direction). Turn
around and make sure the triangle is in the
right place.
Turn around and make sure the triangle is in
32
the right place.
PAGE 13/24 | Calibration manual | 016-8000-015EN | Rev. A