Table 5-1. Front Panel Categories - CPI 0102324500rR Manual

Table 5-1. Front Panel Categories

Category Name
RF Control
Linearizer Control (optional)
RF Trip Limits/Switch Port Relay
Settings
Fault Log
Factory Authorized Access Code
Fault Trip Setting*
Factory Tests*
Reset Elapsed Time Meters*
Reset to Factory Defaults*
HVPS Test Mode**
User Tests
Time/Date Set
Remote Interface Parameters
Mode (If RMTPNL is displayed,
the other selections under this
menu will not be available.)
Computer Interface (CIF)
Parameters
D .01023245 R .R
OC EV
Purpose
-RF Output Setting
-Attenuator Setting
-RF Power Mode
-Gain
-Phase
-High RF Alarm
-High RF Fault
-Low RF Alarm
-Low RF Fault
-Helix Over Voltage Fault
-Helix Under Voltage Fault
-Reset Heater Elapsed Time Meter
-Reset Beam On Elapsed Meter
-Lamp Test
-Beeper Mute
-User Set Heater Time Delay
-12/24 Hour Format
-Hour:Minute
-Set Month
-Device Address
-Baud
-Parity
-Protocol
-Check Byte Type
-Device Address
-Baud
-Parity
-Protocol
-Check Byte Type
THIS DOCUMENT IS THE PROPERTY OF COMMUNICATIONS & POWER INDUSTRIES.
REPRODUCTION OR RELEASE WITHOUT EXPRESS PERMISSION IS STRICTLY PROHIBITED
CHPA S
-RF Inhibit
-RF Display (W, dBW, dBm)
-Suppress Peak Mode (disables
RF peak mode metering)
-Amplitude
-High Reflected RF Fault
-Low RF Relay Preference
-Fault Relay Preference
-Helix Avg Over Current Fault
-Helix Voltage Detect in Standby
-Aux Serial Port Loopback
-Date
-Year
-US Daylight Savings
-CR Enable
-LF Enable
-Accept Bad Check Byte
-Loopback Test
-Installation Test
-CR Enable
-LF Enable
-Accept Bad Check Byte
-Loopback Test
-Installation Test
ERIES
5-11