CPI 0102324500rR Manual page 101

The sample screen (Lines 1-3) for RF Control is as follows:
L O C A L
S T A N D B Y
R F C O N T R O L
Depending on the RF Display setting, either of the first two lines will appear on Line 4 for the
RF Out Setting. Pressing the FUNCTION button will toggle through the remaining entries:
S E T R F
S E T R F
S E T A T T N
RF Power Mode (either ALC or Open Loop):
R F M O D E : A L C
R F M O D E : O P E N
R F I N H I B I T : Y E S
R F D I S P L A Y : D B W
P E A K S U P P R E S S : Y E S
B.11.3 Linearizer Control (optional)
If S1-1 (DIP switch bank) on the Controller Interface (01020360) board is ON, this menu will
appear and be active.
The linearizer has three settings: Gain, Phase, Amplitude. Either the keyboard or arrow keys
may be used to change the setting for any parameter—values range from 0 to 253. The linearizer
settings are stored in the linearizer; the command to store all three settings in the linearizer will
be sent only if the user leaves the Linearizer Control menu after changing a value.
L O C A L
S T A N D B Y
L I N E A R I Z E R
G A I N : 2 5 0
P H A S E : 2 5 0
A M P L I T U D E : 2 5 0
D .01023245 R .R
OC EV
O U T
O U T
C O N T R O L
THIS DOCUMENT IS THE PROPERTY OF COMMUNICATIONS & POWER INDUSTRIES.
REPRODUCTION OR RELEASE WITHOUT EXPRESS PERMISSION IS STRICTLY PROHIBITED
L O O P
CHPA S
ERIES
1 5 : 2 7
X X X X W
X X . X D B W
X X . X D B
1 5 : 2 7
B-13
T
T