General Operation; Multiplexed Reference; Internal Reference; External Reference - CPI 0102324500rR Manual

CHPA S
ERIES
E.2 General Operation
The BUC converts the L-Band input frequency to the frequency required by the TWT through
adding the frequency of local oscillation (F
All BUC's require a reference signal to operate properly. This reference signal is typically
10MHz, however can be a different value. If the BUC F
capture range, a "BUC alarm" or "BUC fault" signal will be reported by the amplifier.
In the event that the BUC F
inhibit RF and shutdown HV to the TWT. A reset command will restore the amplifier to normal
operation once the fault is cleared.
The F reference can be supplied in one of the following three ways:
LO
•
Multiplexed - F reference is multiplexed with the L-Band input signal.
LO
•
Internal - F reference is generated internal to the BUC.
LO
•
External - F reference through a dedicated reference port.
LO
Caution: For multiplexed and external F
input signal must be free of the spurious signals that can cause poor
performance. Spurious signals may also cause the amplifier to fail.
E.2.1

Multiplexed Reference

Most L-band modems now have a built-in 10 MHz reference. A multiplexed reference BUC is
configured to accept this reference multiplexed with the L-band input signal on the same
connector. This is CPI's standard configuration and is recommended for most applications.
The level of the F reference should be +5 to -5 dBm at the amplifiers input.
LO
Caution: Use a multiplexer rather than a combiner. If a combiner is used,
install a band pass filter to the output of the modem or add a 10 dB fixed
attenuator to the input of each combiner.
E.2.2

Internal Reference

reference signal with ±1 ppm stability is included in the BUC. The oscillator
An internal F
LO
performance is not as precise as a GPS reference, but it is adequate for many applications.
E.2.3

External Reference

This allows the user to connect a system 10 MHz reference through a separate amplifier input.
The external reference is used for systems that need to slave all amplifiers to a common timing
reference, such as the GPS signal. The F
E-2
REPRODUCTION OR RELEASE WITHOUT EXPRESS PERMISSION IS STRICTLY PROHIBITED
) to the L-Band input frequency.
LO
becomes unlocked and a fault signal is reported the amplifier will
LO
reference level required is +5 to -5 dBm.
LO
THIS DOCUMENT IS THE PROPERTY OF COMMUNICATIONS & POWER INDUSTRIES.
reference fails or drifts outside of the
LO
reference BUC's, the L-band
LO
D .01023245 R .R
OC EV