Connect The Access Point - Watchguard AP430CR Hardware Manual
Hide thumbs
Also See for AP430CR:
- Hardware manual (32 pages) ,
- Quick start manual (2 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
WatchGuard AP430CR Hardware Guide
Connect the Access Point
Plug one end of the Ethernet cable from your network into the LAN 1 (PoE+) port on the bottom panel of the
access point.
Make sure the other end of the Ethernet cable is connected to your network through a hub, switch, or
injector with PoE+ (802.3at) power enabled.
WatchGuard Technologies, Inc.
16
Advertisement
Table of Contents
