Table of Contents
Advertisement
5
DEVICE OPERATION INSTRUCTIONS
5.1
CHECK CONNECTION
2.
The default factory IP address for IP camera is 192.168.1.168 and the subnet mask is 255.255.255.0. Allocate to
your computer an IP address in the same network segment as the IP camera, for example, 192.168.1.69, and a
same subnet mask as that of the IP camera.
3.
Test whether the IP camera is connected properly and started normally by clicking on Start > Run and entering
"cmd" and pressing ENTER, and entering "ping 192.168.1.168" in the command line window to
4.
Check whether the IP camera is accessible. If the PING command is executed successfully, it indicates that the IP
camera operates normally and the network is connected properly. If the PING command fails, check IP address and
gateway setting of the PC and connectivity of the network.
5.2
SEARCHING FOR THE DEVICE
5.
Feedback: The Device Config Tool function may be used to search for the device across network segments. Before
running the Device Config Tool, select the local connection icon at the bottom right corner of the desktop;
Add the IP addresses of several network segments in the TCP/IP local area connection settings (as shown below).
6.
You can run this tool to search for any device with an IP address in the same network segment.
DS1099-024B
11
Advertisement
Table of Contents
