Initializing The Transmitter/Battery Holder For The First Time; Temperature Display; Flame Height Time - Napoleon LV50N2 Installation And Operating Instructions Manual

50
8.2

INITIALIZING THE TRANSMITTER/BATTERY HOLDER FOR THE FIRST TIME

NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS OF PRESSING
EN
EN
THE RESET/PROGRAM BUTTON (PRG).
A.
Install the 4 AA batteries into the Profl ame 2 battery holder, note the polarity of the batteries and
insert as indicated on the cover (+/-).
B. Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C. Press the reset/programming button, use a small object such as a paper clip in order to reach the
button marked PRG, as shown in the illustration below.
D. The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E. Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
8.3

TEMPERATURE DISPLAY

A. With the system in the "OFF" position, press the
Temperature Key and the Mode Key at the same
time to change from degrees F to C.
B. Look at the LCD screen on the Transmitter to
verify that a C or F is visible to the right of the
Room Temperature display.
8.4

FLAME HEIGHT TIME

The remote control has six (6) fl ame levels. With the
system on and the fl ame level at the maximum, press
the Down Arrow Key once and it will reduce the fl ame
height by one step until the fl ame is turned off.
The Up Arrow Key will increase the fl ame height each
time it is pressed. If the Up Arrow Key is pressed while
the system is on but the fl ame is off, the fl ame will
come on the high position. A single "beep" will confi rm
reception of the command.
W415-1624 / D / 11.22.16
°F
73
35.5A
76
°F
OFF
FLAME OFF FLAME AT LEVEL 1
76
°F
FLAME AT LEVEL 5 FLAME AT "HI" LEVEL 6
35.8A
TRANSMITTER
°C
23
76
°F
76
°F
Hi