Minimum Clearance To Combustible Enclosures - Napoleon LV50N2 Installation And Operating Instructions Manual

34
5.4

MINIMUM CLEARANCE TO COMBUSTIBLE ENCLOSURES

EN
EN
THE FRONT OF THE APPLIANCE MUST BE FINISHED WITH ANY NON-COMBUSTIBLE MATERIALS
SUCH AS BRICK, MARBLE, GRANITE, ETC., AS LONG AS THESE MATERIALS NEVER OVERHANG
IMPORTANT: The LV50 requires a minimum inside enclosure height of 75 1/4" (191.1cm) for see-
through and 58" (147.3cm) for single sided, measured from the bottom of the appliance. For temperature
requirements, this area must be left unobstructed. It is also recommended that the enclosure be ventilated
at the top and bottom to circulate the hot air.
Before fi nishing in the appliance test the operation using the remote control, cycling it through all of its
different modes, see "OPERATION" section. Check pressure readings, see "PILOT BURNER ADJUSTMENT"
section. Once fi nished in, access to the control components can only be done through the inside of the
appliance.
SEE-THROUGH
75 1/4"
191.1cm
MINIMUM
ENCLOSURE
HEIGHT
* Within the appliance enclosure a 6" (152mm) clearance between the top of the vent pipe and combustible
materials is required. All other clearances within the enclosure, including where the vent pipe exits the
enclosure are subject to 2" (51mm) to the sides and bottom and 3" (76mm) to the top for horizontal and 1"
(25mm) for vertical.
** See venting section.
W415-1624 / D / 11.22.16
INTO THE APPLIANCE OPENING.
NOTE: JOINT COMPOUNDS AND TAPES THAT ARE
RESILIENT TO HEAT AND CRACKING SHOULD BE
USED WHEN TAPING AND MUDDING SEAMS.
STEEL STUD FRAME
HEAT SHIELD
26 1/2"
67.3cm
MINIMUM
TOP OF
25 3/4"
APPLIANCE
65.4cm
OPENING
MINIMUM
NON-COMBUSTIBLE
COMBUSTIBLE
MATERIAL
WARNING
!
COMBUSTIBLE
6"
TOP OF
152mm *
ENCLOSURE
7" 179mm
TO SIDEWALL
NON-COMBUSTIBLE
0" IF NON-COMBUSTIBLE
FINISHING IS USED SUCH
AS BRICK AND STONE.
3"
76mm
2"
51mm
65 1/4"
165.7cm
MINIMUM
PLUS RISE**