Operation; General Transmitter Layout; Initializing The Transmitter/Battery Holder For The First Time - Napoleon HD81NT-1 Installation And Operating Instructions Manual

8.0 OPERATION

8.1

GENERAL TRANSMITTER LAYOUT

8.2

INITIALIZING THE TRANSMITTER/BATTERY HOLDER FOR THE FIRST TIME

A. Install the 4 AA batteries into the Profl ame 2 battery holder, note the polarity of the batteries and
insert as indicated on the cover (+/-).
B. Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C. Press the reset/programming button, use a small object such as a paper clip in order to reach the
button marked PRG, as shown in the illustration below.
D. The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E. Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS OF PRESSING THE
RESET/PROGRAM BUTTON (PRG).
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
REAR SIDE
TRANSMISSION
LOW BATTERY
ALARM
TEMPERATURE SET POINT/ LEVEL/ STATUS
FLAME
BUTTON (PRG)
TRANSMITTER
CHILD SAFETY
LOCK OUT
ROOM
TEMPERATURE
AUX. OUTPUT SPLIT VALVE
FAN
35.18A
FRONT SIDE
BLUE LCD DISPLAY
ON/OFF KEY
TEMPERATURE KEY
UP/DOWN
ARROW KEY
MODE KEY
W415-2201 / C / 07.04.19
37
EN