Torque Adjustment - Deprag 347-228U Operating Instruction Booklet

half-round
bore
adjustment nut
Picture: Exchange of clutch spring
Make sure to screw adjustment (adjusting) nut onto clutch bearing
until one line of the thread is visible.

4.2. Torque Adjustment

For an external torque adjustment use the following steps:
1. Disconnect the screwdriver from the air supply.
2. Insert the supplied hand screwdriver 326240 through the slot on the
clutch bearing into the half-round bore of the lock ring (if necessary, turn
bit by hand).
3. By turning the hand screwdriver clockwise (-), the torque is reduced and
by turning it counter-clockwise (+), the torque is increased.
slot for torque
adjustment
Picture: Torque Adjustment
clutch spring
14
claw of the
intermediate ring