Endress+Hauser Fieldbus Levelflex M FMP43 Operating Instructions Manual page 33

Levelflex M FMP43 with FOUNDATION Fieldbus
The highlighted parameters can be edited by on-site operation.
The highlighted parameters can be edited by remote operation.
Endress+Hauser
5.1.1 On-site operation
Options for on-site operation
•Display and operating module VU331
•Endress+Hauser operating software ("FieldCare")
Parameter access by on-site operation
The following parameters can be accessed by on-site operation:
•Parameters of the instrument specific blocks (Sensor Block, Diagnostic Block, Display Block)
•Endress+Hauser service parameters
•in the Resource Block: "Instrument Tag", "Instrument ID", "Instrument Revision", "DD Revision"
(read only)
Sensorblock
Diagnoseblock
Display-Block
Endress+Hauser
Service-Parameter
5.1.2 Remote operation
Options for remote operation
•FOUNDATION Fieldbus configuration tool (e.g. DeltaV or ControlCare)
•Handheld terminal Field Communicator 375/FC375
Parameter access by remote operation
The following parameters can be accessed by remote operation:
•Parameters of the instrument specific blocks (Sensor Block, Diagnostic Block, Display Block)
•Parameters of the FOUNDATION Fieldbus function blocks
Sensorblock
Diagnoseblock
Display-Block
Endress+Hauser
Service-Parameter
Resource Block Arithmetik-Block
AI-Block 1 Input-Selector-Block
AI-Block 2 Signal-Charact.-Block
PID Block Integrator-Block
Resource Block Arithmetik-Block
AI-Block 1 Input-Selector-Block
AI-Block 2 Signal-Charact.-Block
PID Block Integrator-Block
Operation
L00-FMU4XXXX-02-00-00-YY-005
L00-FMU4XXXX-02-00-00-YY-006
33