Compliance - Eiki EK-306U Owner's Manual

Compliance

FCC Caution
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the
instructions. If such changes or modifications should be made, you could be required to stop operation of
the equipment.
Model Number : EK-300 series
Trade Name : EIKI
Responsible party : EIKI International, Inc.
Address : 30251 Esperanza Rancho Santa Margarita CA 92688-2132
Telephone No. : 800-242-3454 (949-457-0200)
AC Power Cord Requirement
The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.
AC Power Cord for the United States and Canada:
AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL)
and certified by the Canadian Standard Association (CSA).
AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug will fit
into the power outlet. Do not try to defeat this safety feature. Should you be unable to insert the plug into
the outlet, contact the electrician.
AC Power Cord for the United Kingdom:
This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the
pin face of the plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be
used of the same rating, marked thus . If the fuse cover is detachable, never use the plug with the
ASA
cover omitted. If a replacement fuse cover is required, ensure it is of the same colour as that visible on
the pin face of the plug (i.e. red or orange). Fuse covers are available from the Parts Department
indicated in the User Instructions.
If the plug supplied is not suitable for the socket outlet, it should be cut off and destroyed.
The end of the flexible cord should be suitably prepared and the correct plug fitted.
WARNING : A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE
SOCKET OUTLET.
The Wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow . . . . . . . . Earth
Blue . . . . . . . . . . . . . . . . . Neutral
Brown . . . . . . . . . . . . . . . Live
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured
markings identifying the terminals in the plug proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is
marked by the letter E or by the safety earth symbol
The wire which is coloured blue must be connected
coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured red.
WARNING: THIS APPARATUS MUST BE EARTHED.
THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.
8
or coloured green or green-and-yellow.
to the terminal which is marked with the letter N or
Accessories
AC Power cord
Remote control with batteries
(AAA or LR3)
INPUT
VGA VIDEO HDMI
AUTO MENU
INPUT
VGA VIDEO HDMI
KEYSTONE AUTO IMAGE MENU FREEZE PATTERN
SCREEN LAMP MUTE INFO.
BLANK
+ +
D.ZOOM VOLUME TIMER
- -
KEYSTONE IMAGE FREEZE PATTERN
SCREEN LAMP MUTE INFO.
BLANK
+ +
D.ZOOM VOLUME TIMER
- -
Safety Guide
KEYSTONE IMAGE FREEZE PATTERN KEYSTONE IMAGE FREEZE PATTERN
SCREEN LAMP MUTE INFO.
SCREEN LAMP MUTE INFO.
BLANK
BLANK + +
+ +
D.ZOOM VOLUME TIMER
D.ZOOM VOLUME TIMER - -
- -
VGA cable
*For EK-307W
HDMI cable
*For EK-306U
INPUT
VGA VIDEO HDMI
AUTO MENU
KEYSTONE IMAGE FREEZE PATTERN
SCREEN LAMP MUTE INFO.
BLANK
+ +
D.ZOOM VOLUME TIMER
- -
Quick start guide
9