Back Panel - LDG AT-1000PROII Operation Manual

Back Panel

The rear panel of the AT-1000ProII has seven jacks.
• Ant 1: Connect a 50 ohm antenna coax feedline to this SO-239 connector. This jack is
automatically disconnected when the AT1000ProII is turned off.
• Ant 2: Connect a second 50 ohm antenna coax feedline to this SO-239 connector. This is the
antenna jack that is active when the ANT 2 LED is lit on the front panel. Also, this jack is
active when the AT1000ProII is turned off.
• Gnd (wing nut): Connect to the antenna system ground.
• Tx: Connect a 50 ohm jumper coax from this jack to the ANT jack on the rear of the amplifier.
• Ext. Meter: Connect the LDG M1000 External Meter to this jack, or use for remote control
via PC.
• Radio: (optional) Connect the optional IC-PAC (Icom), Y-ACC (Yaesu), IC-2000 (Yaesu FT-
2000), or AL-PAC (Alinco) radio interface cable.
• Power: Connect the supplied DC coaxial power cable to this connector, and connect to a
source of 11-16 VDC @ 1A. Center pin is positive.
PAGE 6