Specifications; An Important Word About Power Levels; Important Safety Warning - LDG AT-1000PROII Operation Manual

SPECIFICATIONS

• Transmit Power Rating, 1.8 to 30 MHz:
• Single Side Band: 1000 watts
• CW: 750 Watts
• Digital (RTTY/Packet/PSK31, etc): 500 Watts
• Transmit Power Rating, 50-54 MHz: 250 watts, all modes.
• Silver-teflon SO-239 connectors.
• Built-in 2-port antenna switch, with 2,000 memories each.
• Tuning time 0.2 to 15 seconds full tune, 0.2 seconds memory tune.
• 1.8 to 54.0 MHz coverage. Built-in frequency sensor.
• Tunes 6 to 1,000 ohm loads (16 to 150 on 6m), 6 to 4,000 ohms with optional 4:1 balun.
• LED bargraph displays power level, SWR, and status.
• Antenna Indicator LED shows the currently selected antenna.
• Bypass LED shows when tuner is in pass-thru.
• User-selectable operating parameters: Auto/Semi, 1kW/100W watt scale, and more.
• Optional radio interfaces for ICOM, Yaesu, and Alinco radios available.
• Optional large-display external analog panel meter.
• Power requirements: 11 to 16 VDC @ 1A max.
• Dimensions: 11" x 10" x 3" Weight 4 pounds, 10 oz.

AN IMPORTANT WORD ABOUT POWER LEVELS

The AT-1000ProII is rated at 1000 watts maximum power input at most. Many amplifiers
output well over 1000 watts. Power levels that significantly exceed specifications will most
likely damage or destroy your AT-1000ProII. If the tuner fails during overload, it could also
damage your transmitter, amplifier, or transceiver. Be sure to observe the specified power
limitations.
Never install antennas or transmission lines over or near power lines. You can be
seriously injured or killed if any part of the antenna, support, or transmission line touches
a power line. Always follow this antenna safety rule: The distance to the nearest power line
should be at least twice the length of the longest antenna, transmission line, or support
dimension.

IMPORTANT SAFETY WARNING

PAGE 4