Wi-Fi Button - Devolo Magic 2 WiFi next Manual

* Information about the web interface can be
found in Chapter 4 Network configuration.
** Information about improving the transmission
rate can be found in Chapter 5.2 Connection tips.
***A devolo Magic adapter switches to standby
mode after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface and Wi-Fi is switched off. In this
mode, the devolo Magic adapter cannot be
accessed over the electrical wiring. As soon as the
network device (e.g. computer) connected to the
network interface is switched on again, your
devolo Magic adapter can also be accessed again
over the electrical wiring.
Check whether the adapter is connected to
the power supply correctly and whether the
pairing operation has been carried out suc-
cessfully. For more information about this,
refer to
3.3
devolo Magic 2 WiFi next.

2.2.3Wi-Fi button

This button controls the following functions:
Wi-Fi on/off
In the factory default settings, Wi-Fi is enabled
and Wi-Fi encryption is set to WPA2. The default
key
devolo Magic 2 WiFi next is the device's Wi-Fi key.
You will find this unique key on the label on the
back of the housing.
Connecting the
Fig. 2: type plate
for the initial installation
devolo Magic 2 WiFi next
Introduction 20
of the