Wi-Fi Button - Devolo Magic 2 WiFi next Manual

19 Introduction
* Information about the web interface can be
found in Chapter 4 Network configuration.
** Information on improving the transmission rate
can be found in Chapter 5.2 Bandwidth optimi-
zation.
***A devolo Magic adapter switches to standby
mode after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface and the Wi-Fi is switched off. In
this mode, the devolo Magic adapter cannot be
accessed over the electrical wiring. As soon as the
network device (e.g. computer) connected to the
network interface is switched on again, your
devolo Magic adapter can also be accessed over
the electrical wiring again.
Check whether the adapter is connected to the
mains supply correctly and whether the pairing
operation has been carried out successfully. For
more information about this, refer to
Connecting the devolo Magic 2 WiFi next.

2.3.2Wi-Fi button

This button controls the following functions:
devolo Magic 2 WiFi next
Wi-Fi on/off
In the factory default settings, the Wi-Fi setting is
already enabled and the Wi-Fi encryption is set to
WPA2. The default WiFi key for the initial
installation of the devolo Magic 2 WiFi next is the
device's WiFi key. You will find the unique key on
the label on the back of the housing.
3.3
Fig. 4: country-specific type plate