Wifi Button - Devolo Magic 1 WiFi 2-1 Manual

17 Introduction
* Information about the web interface can be found in
Chapter 4 Network configuration.
** Information on improving the transmission rate can be
found in Chapter 5.4 Bandwidth optimization.
***A devolo Magic adapter switches to standby mode af-
ter approximately 10 minutes if no active network device
(e.g. computer) is connected to the network interface and
the WiFi is switched off. In this mode, the devolo Magic ad-
apter cannot be accessed over the electrical wiring. As
soon as the network device (e.g. computer) connected to
the network interface is switched on again, your
devolo Magic adapter can also be accessed over the
electrical wiring again.
Check whether the adapter is connected to the mains
supply correctly and whether the pairing operation
has been carried out successfully. For more informati-
on about this, refer to
devolo Magic 1 WiFi.

2.3.2 WiFi button

This button controls the following functions:
WiFi on/off
In the factory default settings, the WiFi setting is already
enabled and the WiFi encryption is set to WPA2. The de-
devolo Magic 1 WiFi
fault WiFi key for the initial installation of the
devolo Magic 1 WiFi is the device's WiFi key. You will find
the unique key on the label on the back of the housing.
3.3 Connecting the
Fig. 4: Type plate