Assembly - Tar River SRB-870 Owner's Manual

Mini Round Baler SRB-870
The PTO shaft, twine and electrical connections are located in the twine storage compartment (under the lid at
front of the baler). The wheels are located inside the bale opener door (at rear of the baler). See "Attaching
Wheels" (page 12) for instruction on how to remove wheels from baler chamber.
Attaching to a tractor:
It is best to attach the baler to the tractor on a level surface.
•
Back the tractor to the baler making sure the tractor lower arms are level with the baler's lower hitch pins.
•
Caution: Be sure that no one is between the tractor and the baler when backing.
Secure the tractor's lower arms to the baler's lower hitch pins with lynch pins.
•
Attach the tractor's top link to the baler's upper hitch. Adjust the top link so that the baler is level on the
•
ground.
If baler is in the shipping frame, attach baler to tractor using tractor 3-point, remove bolts securing baler to
•
shipping frame, lift baler, remove and properly discard the shipping frame.
Connecting Hydraulic Control:
Connect the ring ends of the cables to the tractor battery. The black cable supplies power to the Hydraulic
Control (yellow box). The white cable supplies power to the alarm/buzzer. Connect the red wires to the posi-
tive and blue wires to the ground. Note: If the Binding Arm is not raised, the alarm will sound. Either raise arm
or disconnect the white cable at the quick connect near the machine and re-connect before baling.
Route the cables along the tractor frame so they are protected from damage. Leave enough slack in the cables
to prevent stretching and damaging wires when making turns. Cables should be secured to tractor using cable
ties.

Assembly

11
To Tractor Battery