Assembly - Tar River SSP-250 Operator's Manual

Spreader Poly SSP-250, SSP-400
Hopper
1. Secure the spreader hopper support pan to the bottom of the hopper with the 4 carriage head
bolts and nuts.
2. With the hopper opening facing up, insert the Retainer Bushing through the center hole of
the hop- per. The bushing rim should be on the inside of the hopper against the metal bowl.
3. Turn the hopper upside down.
4. Slip the 2-hole (Top Shutter Plate Flow Control) Galvanized disc over the bushing and
against the hopper bottom.
5. Do the same with the 3-hole (Bottom shutter Plate Directional Control) Galvanized disc.
Important: See photo to be sure the discs are flipped the proper way.
6. Put the 4 3/8" washer over the Retainer bushing.
Secure everything in place with the spanner nut or snap ring.
IMPORTANT: Make sure both holes can be exposed after the discs are assembled. If
not assembled correctly, the openings will not line up when the gates are supposed to
be open.

Assembly

12